Installation guide

56 Brocade ServerIron ADX Installation Guide
53-1003445-01
Verifying proper operation
2
12 x 1G Copper Ethernet Interface Module
Pwr On The module is receiving
power.
Off The module is not receiving power. You
can do the following:
• Make certain that the module is
installed properly. For more
information, refer to “Installing
modules in ServerIron ADX chassis
devices” on page 23.
• If using AC power supplies, see the
entry for the AC power supply LED
in this table for more information.
Lnk/Act On or blinking On means a link is
established with the
remote port (no traffic).
Blinking means that the
port is transmitting and
receiving packets.
Note: There is one LED per
port. Refer to “Matching
LEDs to locations on
ServerIron ADX chassis
device modules” on
page 58 for information
on matching each LED to
the correct port.
Off A link is not established with the remote
port and no traffic is being transmitted
or received.
12 x 1G SFP Fiber Ethernet Interface Module
Pwr On The module is receiving
power.
Off The module is not receiving power. You
can do the following:
• Make certain that the module is
installed properly. For more
information, refer to “Installing
modules in ServerIron ADX chassis
devices” on page 23.
• If using AC power supplies, see the
entry for the AC power supply LED
in this table for more information.
Lnk/Act On or blinking On means a link is
established with the
remote port (no traffic).
Blinking means that the
port is transmitting and
receiving packets.
Note: There is one LED per
port. Refer to “Matching
LEDs to locations on
ServerIron ADX chassis
device modules” on
page 58 for information
on matching each LED to
the correct port.
Off A link is not established with the remote
port or traffic is not being passed on
the port.
TABLE 3 LED States After System Power On - ServerIron ADX 4000, ServerIron ADX 8000 and ServerIron ADX 10000 (Continued)
LED Desired State Meaning Abnormal State Meaning/Action