Installation guide

Brocade ServerIron ADX Installation Guide 55
53-1003445-01
Verifying proper operation
2
Mgmt
(10/100/1000
Ethernet port)
On or blinking (yellow) The port is transmitting
and receiving packets.
Off for an
extended
period
The port is not transmitting or receiving
packets. You can do the following:
Check the other 10/100/1000
Ethernet port LED to make sure that a
link is established with the remote port.
If not, take the actions described in the
Meaning/Action column for the other
remote port LED.
AUX1/AUX2 Not supported in this
release
4 x 10G XFP Fiber Ethernet Interface Module
Pwr On The module is receiving
power.
Off The module is not receiving power. You
can do the following:
• Make certain that the module is
installed properly. For more
information, refer to “Installing
modules in ServerIron ADX chassis
devices” on page 23.
• If using AC power supplies, see the
entry for the AC power supply LED
in this table for more information.
Lnk Solid green A link is established with
the remote port.
Note: There is one LED per
port. Refer to “Matching
LEDs to locations on
ServerIron ADX chassis
device modules” on
page 58 for information
on matching each LED to
the correct port.
Off A link is not established with the remote
port.
Act Blinking green A link is established with
the remote port and traffic
is being passed on the
port.
Off for an
extended
period
A link is not established with the remote
port or traffic is not being passed on
the port.
TABLE 3 LED States After System Power On - ServerIron ADX 4000, ServerIron ADX 8000 and ServerIron ADX 10000 (Continued)
LED Desired State Meaning Abnormal State Meaning/Action