Installation guide

46 Brocade ServerIron ADX Installation Guide
53-1003445-01
Uninstalling ServerIron ADX modules
2
Command Syntax
The Syntax for the disable module and enable module commands is described in the following.
Syntax:disable module slot-lc1 | slot-lc2 | slot-lc3 | slot-lc4
• Selecting the slot-lc1 parameter disables the Interface module in slot 1 of the ServerIron ADX
4000, 8000 & 10000 chassis.
• Selecting the slot-lc2 parameter disables the Interface module in slot 2 of the ServerIron ADX
4000, 8000 & 10000 chassis.
• Selecting the slot-lc3 parameter disables the Interface module in slot 3 of the ServerIron ADX
8000 & 10000 chassis.
• Selecting the slot-lc4 parameter disables the Interface module in slot 4 of the ServerIron ADX
4000, 8000 & 10000 chassis.
Syntax:enable module slot-lc1 | slot-lc2 | slot-lc3 | slot-lc4
• Selecting the slot-lc1 parameter enables the Interface module in slot 1 of the ServerIron ADX
4000, 8000 & 10000 chassis (if it has previously been disabled.).
• Selecting the slot-lc2 parameter disables the Interface module in slot 2 of the ServerIron ADX
4000, 8000 & 10000 chassis (if it has previously been disabled.).
• Selecting the slot-lc3 parameter disables the Interface module in slot 3 of the ServerIron ADX
8000 & 10000 chassis. (if it has previously been disabled.).
• Selecting the slot-lc4 parameter disables the Interface module in slot 4 of the ServerIron ADX
8000 & 10000 chassis. (if it has previously been disabled.).
Uninstalling an Application Switch module
When removing an Application Switch Module (ASM) from a ServerIron 4000, ServerIron 8000 or
ServerIron 10000 you should perform the following actions in the order shown:
1. Execute the disable module command for the ASM being removed to allow the system to
gracefully shutdown functions that are related to the ASM before physically removing it.
2. Physically remove the module from the chassis.
3. If you execute the disable module command for a module but do not physically remove it from
the chassis you can only bring it back on-line by rebooting the system.
NOTE
Removing or disabling an ASM module from an operating ServerIron ADX chassis will affect all traffic
that is moving through that module.
Command Syntax
The syntax for the disable module command is described as follows.
Syntax:disable module slot-asm1 | slot-asm2 | slot-asm3 | slot-asm4
• Selecting the slot-asm1 parameter disables the ASM in slot 1 of the ServerIron ADX 4000,
8000 & 10000 chassis.
• Selecting the slot-asm2 parameter disables the ASM in slot 2 of the ServerIron ADX 4000,
8000 & 10000 chassis.