Installation guide

Brocade ServerIron ADX Installation Guide 33
53-1003445-01
Installing ServerIron ADX
2
Installing power supplies
This section describes how to install power supplies in the ServerIron ADX chassis.
ServerIron ADX 1000 and ServerIron ADX 1000F power supplies
The ServerIron ADX 1000 chassis accommodates up to two power supplies (AC or DC). It is shipped
with one power supply. You must purchase an additional power supply if you want your ServerIron
ADX 1000 equipped for one+one redundancy.
Before installing a power supply, have a large Phillips-head screwdriver on hand.
To install a power supply in the ServerIron ADX 1000 chassis, follow these steps.
1. Unscrew the blank power supply faceplate on the back of the chassis and expose the empty
power supply slot.
2. Remove the power supply from its packaging.
3. Insert the power supply into the empty power supply slot, using the guides provided on either
side of the slot (Figure 25).
CAUTION
Carefully follow the mechanical guides on each side of the power supply slot and make sure the
power supply is properly inserted in the guides. Never insert the power supply upside down.
FIGURE 25 Installing a Power Supply in a ServerIron ADX 1000 Chassis