Installation guide

Brocade ServerIron ADX Installation Guide 31
53-1003445-01
Installing ServerIron ADX
2
Installing the SSL Expansion Module onto a
ServerIron ADX Management Module 2 (MM2)
See Table 1 for a list of the SSL Upgrade Kit components.
Complete the following steps to attach the SSL Expansion Module onto a ServerIron ADX
Management module (MM2).
1. Locate and unpack the ServerIron ADX SSL Upgrade Kit. See Table 1 and Figure 20 for a list
and illustration of the kit contents for MM2.
2. Place the Management module on a table or flat surface. If the three 4-40 nuts are still
installed on the MM2, remove them and set aside to expose the posts.
NOTE
The Management Module 2 (MM2) is shipped preinstalled with three 4-40 nuts with Phillips
drive. The SSL Upgrade Kit contents will have them in case these nuts were removed prior to
the upgrade installation.
3. Line up the posts on the Management module with the holes on the SSL Expansion module
and place the module on the posts.
4. Push down firmly on the SSL Expansion module between the three posts to fully mate the
connector to the Management module.
5. Attach the nuts to the posts and secure firmly using a Phillips screwdriver.
FIGURE 23 Securing the nuts to the posts
1 Posts 2 14-40 nuts with Phillips drive 3 SSL Expansion module 4 Management module
(MM2)