Installation guide

28 Brocade ServerIron ADX Installation Guide
53-1003445-01
Installing ServerIron ADX
2
FIGURE 20 ServerIron ADX SSL Upgrade Kit contents
Installing the SSL Expansion Module onto a
ServerIron ADX Management Module 1 (MM1)
See Table 1 for a list of the SSL Upgrade Kit components.
Complete the following steps to attach the SSL Expansion Module onto a ServerIron ADX
Management module.
1. Locate and unpack the ServerIron ADX SSL Upgrade Kit. See Table 1 and Figure 20 for a list
and illustration of the kit contents for MM1.
2. Place the Management module on a table or flat surface.
3. Line up the posts on the Management module with the holes on the SSL Expansion module
and place the module on the posts.
4. Push down firmly on the SSL Expansion module between the two posts to fully mate the
connector to the Management module.
1 SSL Expansion module 2 14-40 nuts with Phillips drive 3 4-40 x 3/8 Phillips drive pan head screw