Installation guide

26 Brocade ServerIron ADX Installation Guide
53-1003445-01
Installing ServerIron ADX
2
To install a module in the ServerIron ADX 4000, ServerIron ADX 8000 or ServerIron ADX 10000
chassis, follow these steps.
1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on
the chassis front.
2. Remove the module from its packaging.
3. With the ejectors in the outward position, insert the module into the appropriate chassis slot
and slide the card along the card guide until the ejectors on either side of the module move
close to the module front panel.
FIGURE 19 Installing a Module in a ServerIron ADX chassis device
NOTE
When inserting the module into the chassis, make sure that the faceplate does not overlap the
faceplate of an adjacent ASM Module.
4. Push the ejectors in until they are flush with the module front panel. This action will fully seat
the module in the backplane. Modules have a snug fit for maximum EMI protection.
NOTE
The installation instructions for installing modules shown in the following illustrations are
exactly the same for ASM, MM, and SFM, and Ethernet Interface Modules.
5. Tighten the two screws at either end of the module front panel by pushing them in and turning
them clockwise. Then, tighten the screws further using the flat-head screwdriver.