Installation guide

Brocade ServerIron ADX Installation Guide 15
53-1003445-01
Chapter
2
Installing ServerIron ADX
Installation precautions
This chapter contains information on how to install a ServerIron ADX. Before proceeding, please
read the cautions and warnings below that apply to the entire ServerIron ADX family.
DANGER
The procedures in this manual are for qualified service personnel only.
DANGER
If the installation requires a different power cord than the one supplied with the device, make
sure you use a power cord displaying the mark of the safety agency that defines the regulations
for power cords in your country. The mark is your assurance that the power cord can be used
safely with the device.
CAUTION
Product contains ESD sensitive devices, use proper ESD mitigation procedures (such as ESD
grounding wrist straps) before handling.
CAUTION
Before plugging a cable to any port, be sure to discharge the voltage stored on the cable by
touching the electrical contacts to ground surface.
CAUTION
For NEBS Compliant installations: All devices with AC power supplies are intended for installation
in restricted access areas only. A restricted access area is where access can be gained only by
service personnel through the use of a special tool, lock and key, or other means of security, and
is controlled by the authority responsible for the location. (ADX-1000 only)
The ServerIron ADX is suitable for installation in Network Telecommunications facilities and
locations where the NEC (National Electric Code) apply.
Follow these precautions when installing a ServerIron ADX.