User's Manual

Brocade Network Advisor IP User Manual 909

53-1003056-01

802.1ag Connectivity Fault Management

• To send a loopback message to a specific MEP or MIP in the domain, refer to “Sending a

loopback message” on page 911.

• To send a linktrace message to a specific MEP or MIP in the domain, refer to “Sending a

linktrace message” on page 912..

4. Click Close on the Configure 802.1ag CFM dialog box.

Deleting a maintenance association

You can access 802.1ag CFM from the following features:

• VPLS Manager (requires the IP - MPLS – VLL prvilege with read-write or read-only permission)

• VLL Manager (requires the IP - MPLS – VPLS prvilege with read-write or read-only permission)

• VLAN Manager (requires the VLAN Manager prvilege with read-write or read-only permission)

NOTE

802.1ag CFM is only supported on IronWare Ethernet Routers devices running firmware release 5.2

or later.

NOTE

Only maintenance domains that are not linked to other associations will be deleted.

To delete a maintenance association, complete the following steps.

1. Right-click a device and select 802.1ag CFM.

The Configure 802.1ag CFM dialog box displays.

2. Select one or more maintenance associations you want to delete in the Maintenance

Association Details table.

3. Click Delete.

A confirmation message displays with a Delete the maintenance domain? check box. Make

sure that the check box is selected.

4. Click Yes on the confirmation message.