User's Manual

830 Brocade Network Advisor IP User Manual
53-1003056-01
Port VLANs
27
7. Click the Untag button and click the left arrow to assign the port as an untagged port to the
selected VLAN. The Selected Ports list shows the interface listed under the VLAN to which it
was assigned.
8. Select the same interface from the Available Ports list.
9. Select another VLAN from the Select VLANs list.
10. Click the Tag button and click the right arrow to assign the port as a tagged port to the second
VLAN. The Selected Ports list shows the port as untagged under one VLAN and tagged under
another VLAN.
Assigning DCB ports to a VLAN
In Data Center Bridging (DCB) switches, the L2 interface mode of the port determines whether a
port can be in an untagged, tagged, or converged mode. Table 84 shows the L2 mode and tagged
mode compatibility on the DCB interface.
NOTE
To make L2 interface mode changes, you must have the DCB Management privilege.
You can change the L2 interface mode of a port using the Add LAG dialog box. Refer to “Adding a
LAG” on page 493 for instructions.
TABLE 84 L2 mode and tagged mode compatibility on a DCB interface
L2 mode Tagged mode
Access, Converged Untagged
Trunk, Converged Tagged
Converged Dual