User's Manual

Brocade Network Advisor IP User Manual 795
53-1003056-01
Monitoring configurations
25
NOTE
Closing the Deployment Status dialog box does not stop deployment.
To check the results of the deployment in the Product CLI Report, refer to “CLI deployment
reports” on page 802. For details about valid and invalid responses when you deploy a
configuration, refer to “Valid and invalid responses from devices” on page 790.
Monitoring configurations
You can create, modify, duplicate, and delete a monitoring configuration from the CLI Configuration
dialog box. Monitoring configurations allow you to create device reports by entering a set of show
CLI commands. To view a list of existing configurations, refer to “Viewing existing templates” on
page 778. For information about the example templates, refer to “CLI Templates” on page 1339.
Creating a monitoring configuration
To create a new monitoring configuration, complete the following steps.
1. Select Configure > CLI Configuration.
The CLI Configuration dialog box displays.
2. Click Add.
The CLI Template dialog box displays.
FIGURE 308 CLI Template dialog box - Definition tab
3. Click the Definition tab and complete the following steps.
a. Enter a name and description for the new configuration.
NOTE
Do not use special characters in the name.
b. Select Monitoring to create product reports using show commands.
c. To change CLI credentials, click Change Template Credentials and refer to “Changing
product credentials” on page 784.