User's Manual

Brocade Network Advisor IP User Manual 677
53-1003056-01
Adding thresholds
20
State Change threshold
NOTE
This threshold is only available for Fabric OS devices running 6.3 or later.
Use this type of threshold to block a port when a state change violation type meets the Fabric OS
switch threshold.
For 4 Gbps Router, Extension Switches and Blades only, when you apply this threshold on an E Port,
the threshold is also applied to the VE Ports (internally by Fabric OS).
Adding thresholds
NOTE
Only available for Fabric OS products.
NOTE
This feature requires a Trial or Licensed version.
The Management application allows you to create Invalid CRCs, Invalid words, Link, Link Reset,
Protocol Error, Security, and Sync Loss thresholds.
Adding a C3 Discard Frames threshold
NOTE
This threshold is only available for Fabric OS devices running 6.3 or later.
Use to block a port when a C3 Discard Frames violation type meets the Fabric OS switch threshold.
For default threshold values for Fabric OS devices, refer to Chapter 7 of the Fabric Watch
Administrator's Guide.
To add an C3 Discard Frames threshold, complete the following steps.
1. Select Monitor > Fabric Watch > Port Fencing.
The Port Fencing dialog box displays (Figure 243).