User's Manual

Brocade Network Advisor IP User Manual 613
53-1003056-01
Layer 3 access control list policy
18
Creating a service
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 585
• “Editing an extended L3 ACL configuration” on page 587
• “Copying an extended L3 ACL configuration” on page 588
• “Creating an extended L3 ACL configuration” on page 585
• “Editing an IPv6 L3 ACL configuration” on page 592
• “Copying an IPv6 L3 ACL configuration” on page 593
To create a service, complete the following steps.
1. Click the Services tab.
2. Click Add.
The Add Service dialog box displays.
FIGURE 228 Add Service dialog box
3. Enter a name for the service in the Name field.
4. Select one of the following protocol options:
• TCP
• UDP
5. Enter a port number in the Port field.
6. Click OK on the Add Service dialog box.
7. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to “Configuring L3 ACL advanced
settings” on page 598.