User's Manual

Brocade Network Advisor IP User Manual 607
53-1003056-01
Layer 3 access control list policy
18
2. Review the List of Network Groups table:
• Name — The user-defined network group name.
• Host Names — The name of each host in the network group.
• Address Range — The range of IP addresses for the network group.
• Networks — The name of each network in the network group.
• Network Groups — The name of each network group in the network group.
3. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Creating a network group
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 581
• “Editing a standard L3 ACL configuration” on page 584
• “Copying a standard L3 ACL configuration” on page 585
• “Creating an extended L3 ACL configuration” on page 585
• “Editing an extended L3 ACL configuration” on page 587
• “Copying an extended L3 ACL configuration” on page 588
To create a network group, complete the following steps.
1. Click the Network Groups tab.
2. Click Add.
The Add Network Group dialog box displays.
FIGURE 226 Network dialog box, Network Group tab
3. Enter a name for the network group in the Group Name field.