User's Manual

Brocade Network Advisor IP User Manual 603
53-1003056-01
Layer 3 access control list policy
18
1. Click the Networks tab.
FIGURE 223 Network dialog box, Networks tab
2. Review the List of Networks table:
• Name — The user-defined network name.
• Subnet — The IP address of the subnet.
• Mask — The IP address of the mask.
3. Click Close on the Network dialog box.
To finish configuring the ACL, return to one of the above procedures.
Creating a network
You can access the Network dialog box when configuring a standard or extended L3 ACL device
configuration. To configure a standard or extended L3 ACL, refer to one of the following procedures:
• “Creating a standard L3 ACL configuration” on page 581
• “Editing a standard L3 ACL configuration” on page 584
• “Copying a standard L3 ACL configuration” on page 585
• “Creating an extended L3 ACL configuration” on page 585
• “Editing an extended L3 ACL configuration” on page 587
• “Copying an extended L3 ACL configuration” on page 588
To create a network, complete the following steps.
1. Click the Networks tab.
2. Click Add.
The Add Network dialog box displays.
FIGURE 224 Add Network dialog box