User's Manual

580 Brocade Network Advisor IP User Manual
53-1003056-01
Layer 3 access control list policy
18
1. Select the fabric, a node in the fabric, or a standalone device and select Configure > Security >
Layer 2 ACL > Port.
2. Select a port in the Available Ports list and click the right arrow button to move it to the
Selected Port list.
3. Click OK on the Port Selection - Layer 2 ACL dialog box.
The Device/Fabric_Name - Port_Number - Layer 2 ACL Configuration dialog box displays.
Depending on the Display Label you choose, the Device/Fabric_Name is the name of the
device or fabric, the IP address of the device or fabric, or the name and IP address of the
device or fabric.
FIGURE 214 Device/Fabric_Name - Port_Number - Layer 2 ACL Configuration dialog box
4. Review the Layer 2 ACL configuration details.
Details of Selected ACL table — Displays the details of the ACL selected in the ACLs list.The
Details of Selected ACL table includes the following details:
• Sequence — The Layer 2 ACL entry sequence number.
• Action — Whether the ACL permits or denies traffic.
• Source — The source MAC address on which the ACL filters traffic.
• Destination (Extended only) — The destination MAC address on which the ACL filters the
traffic.
• Count — Whether count is enabled or disabled.
• Ether Type (Extended only) — The Ethernet protocol. Values include ARP, FCoE, IPv4, or
Custom.
5. Click OK to close on the Device/Fabric_Name - Port_Number - Layer 2 ACL Configuration dialog
box.
Layer 3 access control list policy
A Layer 3 access control list (L3 ACL) enables you to filter incoming and outgoing traffic based on
the information in the IP packet header.