User's Manual

Brocade Network Advisor IP User Manual 577
53-1003056-01
Layer 2 access control list management
18
4. Click OK on the Device_Name - Layer 2 ACL Configuration dialog box.
NOTE
The Layer 2 ACL configuration is not deleted from the switch until you deploy the configuration
to the switch.
The Deploy to Products - Layer 2 ACL dialog box displays. To save the configuration, refer to
“Saving a security configuration deployment” on page 631.
Network OS Layer 2 ACL configuration
NOTE
You cannot configure a Layer 2 ACL using the Management application. You must configure the
Layer 2 ACL through the Network OS CLI (refer to the Network OS Command Reference).
Once you configure Layer 2 ACLs through the Network OS CLI, you can use the Management
application to view Layer 2 ACL configurations for a VCS fabric or standalone device. You can also
view the Layer 2 ACL that are bound to an interface (ports, LAGs, vLAGs, VLANs, or ports in profile
mode) on the fabric or device.
Viewing Layer 2 ACL configuration on a fabric (Network OS)
To view Layer 2 ACL configurations on a Network OS VCS fabric, complete the following steps.
1. Select the VCS fabric and select Configure > Security > Layer 2 ACL > Product.
The Fabric_Name - Layer 2 ACL Configuration dialog box displays. Depending on the display
label you chose on the IP tab, the Fabric_Name is the name of the fabric, the IP address of the
fabric, or the name and IP address of the fabric.
FIGURE 212 Fabric_Name - Layer 2 ACL Configuration dialog box
2. Select the fabric node from the RBridge list.
By default, the principal switch of the fabric is selected.
3. Review the Layer 2 ACL configuration details.