User's Manual

474 Brocade Network Advisor IP User Manual
53-1003056-01
Host performance management
15
• Port Mapping
• Virtual Network Management
Instructions for managing resource groups and users using roles and privileges are detailed in
“User accounts,”“Roles,” and “Areas of responsibility,” in Chapter 6, “User Account Management”.
Host performance management
Real-time performance enables you to collect data from managed HBA and CNA ports. You can use
real-time performance to configure the following options:
• Select the polling rate from 20 seconds up to 1 minute.
• Select up to 32 ports total from a maximum of 10 devices for graphing performance.
• Choose to display the same Y-axis range for both the Tx MBps and Rx MBps measure types for
easier comparison of graphs.
NOTE
In the Port Picker dialog box, the Brocade 1860 Fabric Adapter in AnyIO mode displays in both
categories (HBA port measures and CNA port measures). The ports are properly filtered to display
only the CNA or HBA port based on the selection.
Table 52 lists the counters that are supported for the FC ports and for the HBA and CNA ports.
TABLE 52 Counters
FC port measures HBA port measures CNA port measures
Tx % utilization Tx % utilization Tx % utilization
Rx % utilization Rx % utilization Rx % utilization
Tx MBps Tx MBps Tx MBps
Rx MBps Rx MBps Rx MBps
CRC errors CRC errors
Signal losses Signal losses
Sync losses Sync losses
Link failures Link failures
Sequence errors Primitive sequence protocol errors
Invalid transmissions
Rx link resets
Tx link resets
NOS count
Error frames
Dropped frames
Undersized frames
Oversized frames
Bad EOF frames