User's Manual

Brocade Network Advisor IP User Manual 169
53-1003056-01
Software Configuration
5
• Large: 1800 seconds
5. Click Apply or OK to save your work.
NOTE
Changes to this option take effect after an application restart.
NOTE
You can only restart the server using the Server Management Console (Start > Programs >
Management_Application_Name 12.X.X > Server Management Console).
6. Click OK on the “changes take effect after application restart” message.
Viewing the network size status
The Management application enables you to view the network size status at a glance by providing a
status icon on the Status Bar. Double-click the icon to launch the Memory Allocation pane of the
Options dialog box.
NOTE
If you exceed the recommended count, the network size status icon refreshes when the License is
refreshed (every three hours) or after a client restart.
NOTE
The recommended count is the supported scalability limit based on the network size. If the
maximum license count is less than the recommended count, the license count displays as the
recommended count.
The following table illustrates and describes the icons that indicate the current network size status.
Product communication settings
You can configure HTTP or HTTPS connections between the products and the Management
application server.
Configuring SAN communication
To configure connections between the SAN devices and the Management application server,
complete the following steps.
TABLE 20
Icon Description
This icon displays when the network size is within the recommended count.
This icon displays when the network size exceeds the recommended count. This icon displays
when any of the following counts are exceeded:
• IP Product Count
• IP Port Count