User's Manual

ManualsBrandsBrocade Communications Systems ManualsNetwork HardwareBrocade Communications Systems Access Point IP250

1371

1322 Brocade Network Advisor IP User Manual

53-1003056-01

IP device properties

Configuration Displays one of the following VLAN configuration options:

• Access mode — Supports MAC address and MAC group

classification.

• Trunk mode

• Add — Adds VLAN IDs to the port profiles.

• Remove — Deletes VLAN IDs to the port profiles.

• All — Indicates that the port profile allows all VLAN IDs.

• None — Indicates that the port profile does not allow any VLAN

IDs.

• All Except <VLAN IDs> — Indicates that the port profile allows

any packet except the VLAN IDs specified.

• <VLAN IDs> — Indicates that the port profile allows any packet

with the VLAN IDs specified.

NOTE: GVLAN supported Trunk Mode supports the Trunk VLAN and the

Native Trunk classifications with the cTag information.

Native VLAN/VLAN Displays one of the following based on the VLAN configuration:

• Access Mode — Displays the associated MAC address or MAC group

or both to a VLAN ID.

• Trunk Mode — Displays the cTag for a VLAN ID or Native VLAN ID or

both.

Associated Domain Lists the domain names associated with the port profile.

QoS tab — DCB mode

Mode The mode of Quality of Service (QoS) assigned to the port (DCB).

DCB Map The DCB map name.

Precedence This number determines the map’s priority. Valid values are from 1

through 100.

Fabric Remap Priority The fabric remap priority of the port. Valid values are CoS 0 through CoS

6, and the default is CoS 0.

Lossless Remap Priority The FCoE lossless remap priority of the port. Valid values are CoS 0

through CoS 6, and the default is CoS 0.

QoS tab — Non-DCB mode (Ethernet PFC with Trust)

Mode The mode of Quality of Service (QoS) assigned to the port (non-DCB).

Trust Indicates whether the Ethernet trust of the port is enabled or disabled.

Flow Control The Ethernet priority flow control mode of the port. Possible modes are

as follows:

• Off (the default)

• 802.3x pause

• Tx On or Off

• Rx On or Off

• Priority Flow Control. For this mode, the Tx and Rx values for each

CoS display in the table.

Maps Displays details about the following DCB maps:

• CoS to CoS — Displays the details of the CoS to CoS map assigned

to the port.

• Traffic Class — Displays the details of the Traffic Class map

assigned to the port.

NOTE: The CoS to CoS map is the default.

Field/Component Description