User's Manual

Brocade Network Advisor IP User Manual 1031
53-1003056-01
IP sFlow configuration
33
20. Select Relative time if the you want to retrieve information relative to a time range, or Absolute
time if you want to run the report at a specific date and hour.
- If you select Relative time, use the Range selector to
- If you select Absolute time, use the Start Date and Start Time selectors to set the time that
data collection begins, and the End Date and End Time selectors to set the time when data
collection ends.
21. Select the Result Settings tab.
FIGURE 432 Add Report Definitions dialog box, Result Settings tab
22. Select one of the following options for displaying report data from Result Type list:
- Detailed Table - Displays data in table format.
- Top N Chart and Table - Displays a pie chart of the top N talkers for your selected sorting
options above tabular data.
- Bottom N Chart and Table - Displays a pie chart of the bottom N talkers above the tabular
data.
For the Bottom N Chart and Table and Top N Chart and Table selections, Total Bytes is
automatically selected under Selected Columns if Total Bytes or Total Frames is not already
selected. The Time column cannot be selected and the Sort By Columns box is not displayed in
the dialog box (refer to Figure 433 on page 1032).