User's Manual

Brocade Network Advisor IP User Manual 963

53-1003056-01

Chapter

Deployment Manager

In this chapter

•Introduction to the Deployment Manager . . . . . . . . . . . . . . . . . . . . . . . . . . 963

•Editing a deployment configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 963

•Duplicating a deployment configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . 964

•Deleting a deployment configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 965

•Deploying a configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 965

•Viewing deployment logs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 965

•Generating a deployment report . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 965

•Generating a deployment configuration snapshot report. . . . . . . . . . . . . . 966

•Searching the configuration snapshots . . . . . . . . . . . . . . . . . . . . . . . . . . . . 966

Introduction to the Deployment Manager

The Deployment Manager allows you to view, edit, duplicate, delete, deploy, and generate reports

for the following types of deployment configurations:

• DCB

• VLAN

• STP

• Security

You cannot create configurations using the Deployment Manager. The deployment configurations

must have been previously created and saved. Refer to the following sections for information about

creating these types of configurations:

• “Fibre Channel over Ethernet” on page 481 (for DCB configurations)

• “VLAN Management” on page 819 (for VLAN and STP configurations)

• “Security Management” on page 561

Deployments that were created through the legacy Configuration Wizard are listed in the

Deployment Manager dialog box, but cannot be modified, deployed, or deleted. You can only

launch reports for these deployments.

Editing a deployment configuration

1. Select Configure > Task Scheduler.

The Task Scheduler dialog box displays, as shown in Figure 395.