User guide

37Fabric OS 4.4.x release notes
Port log "disable" or "enable" entry is
not logged in port log when Fabric
Watch's PortLogLock alarm trigger is
used to log a port log of a port.
Fixed.
When using the bladeDisable or
bladeEnable command there is no
output to the user to let them know
whether the command failed or
succeeded.
Fixed.
If a slot is disabled using
bladeDisable command, the
slotShow command shows the slot as
enabled, this may lead the user to
incorrectly assume that the command
failed.
Fixed.
GUI HA Admin Fails To Indicate The
Sync State Of CPs.
Fixed.
SAN Switch 2/32 displays ENC_ERR
when no cable plugged in on 4.0.2;
SAN Switch 2/8V and 2/16V shows
same error with 4.2
Fixed.
"Do not power cycle" message does
not appear in Web Tools during
firmwaredownload.
Fixed.
With the 3.1.x code, when you run a
cfgshow via a telnet session, it pauses
the output one screen at a time. With
the 4.x code, this is not the case.
Fixed.
Commands fanShow and
sensorShow do not report Fabric
Watch threshold levels correctly.
Fixed.
Table 5 Closed issues for Fabric OS 4.2.2a (continued)
Fabric OS 4.2.2a Issue Status