User guide

27Fabric OS 4.4.x release notes
If the IP addresses are set up on a
network that is configured with IP
address that are 10.0.x.x and a subnet
mask of 255.255.0.0, there will be
routing between eth0 and eth1. This is
not the expected behavior, as eth0
traffic should not be routed to eth1.
Fixed.
Switch ports are set to faulty when
certain tasks are performed in Win2003
clustered environment. A portshow
that was taken before and after starting
the cluster services were started and
shows that the link failure count
increases by the number of attached
disk drives (this means, 33 disks = 33
link failures) At a certain point switch
disables the port and the following error
message is observed:
Switch: 0, Warning
PORT-LINK_FAULT, 3, Port 6 Faulted
because of many Link Failures
Fixed.
Changed the time and the tsd crashed
on all switches in fabric.
Fixed.
There will be no error messages shown
when switch recovery or bootup failed.
Fixed.
For SAN Director 2/128, CP doesn’t
complete its boot sequence.
Fixed.
In a mixed fabric, a SAN Director 2/128 at
the core, panicked and ms daemon died with
error message on the console when a test
script to reboot all the switches in the fabric at
the same time was executed.
Fixed.
Cannot enable long distance mode
from Web Tools.
Fixed.
Table 5 Closed issues for Fabric OS 4.2.2a (continued)
Fabric OS 4.2.2a Issue Status