Specifications

Core Switch 2/64 and SAN Director 2/128 installation guide, part number: AA-RVUSC-TE34
Replace Table 12 on page 76 with the following:
Table12: WWN Bezel LED Patterns
LED location
and purpose
LED Color Status Recommended Action
16-Port card/CP
card Power
Steady green Power is OK No action required.
Flashing green Power to port card is OK;
however, this LED flashes if the
port card status LED is flashing.
Check port card status LED
and determine if it is
flashing slow (2 second
increments) or fast (1/2
second increments) and then
take appropriate action.
No light (LED is
off)
No port card is present or the
power source is unavailable.
Insert port card, or check
AC switch and power
source.
NOTE: Check the individual port card (see Figure 15 on page 81) or CP
card power LEDs (see Figure 16 on page 85) on the port side of the chassis to
confirm the LED patterns.
16-Port card/CP
card Status
Steady Amber Port card is faulty. Check port card.
Slow-flashing
amber (2
seconds on;
then 2 seconds
off)
Port card is not seated correctly
or is faulty.
Pull card out and reseat it. If
LED continues to flash,
replace card.
Fast-flashing
amber (1/2
second on;
then 1/2
second off)
Environmental range exceeded
or port card failed diagnostics
(run during POST or manually).
Check for out-of-bounds
environmental range and
correct it. Replace card if it
fails diagnostics.
No light (LED is
off)
Port card is either healthy or
does not have power.
Verify that the port card
power LED is on.