Technical data

Switching and Routing
May 2012 © 2012 Brocade Communications Systems, Inc. 2 - 29
This command displays the following information.
Displaying the IP Route Table
To display the IP route table, enter the following command at any level of the CLI:
Syntax: show ip route
Table 2.4: CLI Display of IP Interfaces
This Field... Displays...
Interface The virtual routing interface.
IP-Address The IP address of the interface.
OK? Whether the IP address has been configured on the interface.
Method Whether the IP address has been saved in NVRAM. If you have set
the IP address for the interface in the CLI or Web Management
interface, but have not saved the configuration, the entry for the
interface in the Method field is “manual”.
Status The link status of the interface. The status can be one of the
following:
•down
•up
Protocol Whether the interface can provide two-way communication. If the IP
address is configured, and the link status of the interface is up, the
entry in the protocol field is “up”. Otherwise the entry in the protocol
field is “down”.
ServerIron(config)# show ip route
Total number of IP routes: 9
Start index: 1 D:Connected S:Static *:Candidate default
Destination NetMask Gateway Port Cost Type
1 10.10.10.0 255.255.255.0 0.0.0.0 ve1 1 D
2 20.20.20.0 255.255.255.0 0.0.0.0 ve1 1 D
3 50.50.50.0 255.255.255.0 20.20.20.10 ve1 1 S
4 60.60.60.0 255.255.255.0 20.20.20.10 ve1 1 S
5 70.70.70.0 255.255.255.0 120.120.120.10 ve1 1 S
6 120.120.120.0 255.255.255.0 0.0.0.0 ve1 1 D
7 130.130.130.0 255.255.255.0 0.0.0.0 ve1 1 D
8 192.168.2.0 255.255.255.0 0.0.0.0 ve1 1 D
9 0.0.0.0 0.0.0.0 192.168.2.1 ve1 1 S