Technical data

Viewing FWLB Configuration Details and Statistics
May 31, 2012 © 2012 Brocade Communications Systems, Inc. 9 - 5
USING THE CLI
To display path information for FWLB, enter the following command at any level of the CLI:
The following table describes the information displayed by the show server fw-path command.
Table 9.1: FWLB Path Information
This Field... Displays...
General Information
Number of Fwall The number of firewalls configured in the group.
Target-ip The IP address of the device at the other end of the path. Generally,
this other device is another ServerIron.
Next-hop-ip The IP address of the device at the next hop to the target IP. Usually,
this is the IP interface on the firewall that is connected to this
ServerIron.
Port The ServerIron port for this path. This is the port connected to the
firewall.
Path The path ID.
Status The status of the path, which can be one of the following:
• 0 – The path is down.
• 1 – The path is up.
Tx Indicates the state of the transmit side of the path. The state can be
one of the following:
• 0 – The transmit side is down.
• 1 – The transmit side is up.
ServerIron(config)# show server fw-path
Firewall Server Path Info
Number of Fwall = 4
Target-ip Next-hop-ip Port Path Status Tx Rx State
3.3.3.10 1.1.1.3 1 1 1 1 1 3
3.3.3.10 1.1.1.4 2 2 1 1 1 3
4.4.4.10 1.1.1.3 1 3 1 1 1 5
4.4.4.10 1.1.1.4 2 4 1 1 1 5
State = 5 :Partner known = No :port = 1
Activates = 2 Inactivations = 2
Current Local Partner
State 5 5 5
Priority 5 5 10
Path-cnt 4 4 4
Active path cnt = 2, list = 3 4