Technical data

8-12 Fabric OS MIB Reference Manual
Publication Number: 53-0000521-08
Connectivity Group
8
Description This is a unique ID, persistent between boots, that can be used to group a set of
connUnits together into a module. The intended use would be to create a connUnit
with a connUnitType of “module” to represent a physical or logical group of
connectivity units. Then the value of the group would be set to the value of
connUnitId for this “container” connUnit.
connUnitModuleId should be 0s if this connUnit is not part of a module.
Note Set to the WWN of the switch.
connUnitName
OID 1.3.6.1.3.94.1.6.1.20
Description A display string containing a name for this connectivity unit. This object value should
be persistent between boots.
Note Set to switchName/sysName.
connUnitInfo
OID 1.3.6.1.3.94.1.6.1.21
Description A display string containing information about this connectivity unit. This object value
should be persistent between boots.
Note Set to sysDescr and read-only.
connUnitControl
OID 1.3.6.1.3.94.1.6.1.22
Description Controls the addressed connUnit. Each implementation might choose not to allow any
or all of these values on a SET. Possible values are:
unknown (1)
invalid (2)
resetConnUnitColdStart (3): Reboot. Performs a switch reboot.
resetConnUnitWarmStart (4): Fastboot. The addressed unit performs a Warm
Start reset.
offlineConnUnit (5): Disable switch. The addressed unit puts itself into
an implementation-dependant offline state. In general, if a unit is in an offline
state, it cannot be used to perform meaningful Fibre Channel work.
onlineConnUnit (6): Enable switch. The addressed unit puts itself into
an implementation-dependant online state. In general, if a unit is in an online
state, it is capable of performing meaningful Fibre Channel work.
Cold start and warm start are as defined in MIB-II and are not meant to be a factory
reset.
This is similar to swAdmStatus:
resetConnunitColdStart = reboot