Technical data

1-6 Fabric OS MIB Reference Manual

Publication Number: 53-0000521-08

Fabric OS Commands for Configuring SNMP

Brocade MIB Files

The following Brocade MIBs can be found in a "mibs" subdirectory after uncompressing the v4.4.0

firmware file.

• BRCD_v5_0.mib

• SW_v5_2.mib

• HA_v5_1.mib

• FICON_v5_0.mib

• FA_v3_0.mib

• ENTITY_RFC2737.mib

• FE_RFC2837.mib

Unsupported SilkWorm 4100 Features in the MIB

The current version of the MIB does not support the following SilkWorm 4100 features:

• Routing policy management

• Buffer credit management, including degraded ports and enable/disable of buffer-credit sharing

• Ports on Demand license

Fabric OS Commands for Configuring SNMP

Use the following commands to configure MIBs in the Fabric OS. Refer to the Fabric OS Procedures

Guide for on procedures on configuring SNMP on the SilkWorm switches.

Table 1-2 Commands for Configuring SNMP

Command Description

snmpConfig Introduced in Fabric OS v4.4, this command has all the features of existing

the agtcfg* commands and in addition it has SNMPv3 configuration

parameters.

snmpMibCapSet Enhanced in Fabric OS v4.4 to provide a filter facility at the trap level

(previously the filter facility was at MIB level for traps).

snmpMibCapShow Displays the settings in the snmpMibCapSet command.

agtcfgDefault Resets the traps to the default values. This command is retained for legacy

reasons, but is replaced functionally by the snmpConfig command.

agtcfgSet Used to set the trap values for SNMP. This command is retained for legacy

reasons, but is replaced functionally by the snmpMibCapSet command.

agtcfgShow Used to display the configuration of the SNMP values. This command is

retained for legacy reasons, but is replaced functionally by the

snmpMibCapShow command.