Technical data

Fabric OS MIB Reference Manual 5-31
Publication Number: 53-0000521-08
Fibre Channel Port Group
5
portFault (7) The port is marked faulty (defective GBIC, cable, or device).
diagFault (8) The port failed diagnostics (defective G_Port or FL_Port card
or motherboard).
lockRef (9) Port is locking to the reference signal.
swFCPortOpStatus
OID 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.4
Description The operational status of the port. Possible values are:
unknown (0) The port module is physically absent.
online (1) User frames can be passed.
offline (2) No user frames can be passed.
testing (3) No user frames can be passed.
faulty (4) The port module is physically faulty.
swFCPortAdmStatus
OID 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.5
Description The desired state of the port. A management station might place the port in a desired
state by setting this object accordingly. Possible values are:
online (1) User frames can be passed.
offline (2) No user frames can be passed.
testing (3) No user frames can be passed.
faulty (4) No user frames can be passed.
Note For Fabric OS v3.x:
The 3 (testing) state indicates that no user frames can be passed. As the result of either
explicit management action or per configuration information accessible by the switch,
swFCPortAdmStatus is then changed to either the 1 (online) or 3 (testing) states or
remains in the 2 (offline) state.
For Fabric OS v4.x:
The 3 (testing) state is not supported.
swFCPortLinkState
OID 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.6
Description Indicates the link state of the port.
enabled (1) The port is allowed to participate in the FC-PH protocol with
its attached port (or ports if it is in an FC-AL loop).
disabled (2) The port is not allowed to participate in the FC-PH protocol
with its attached ports.
loopback (3) The port might transmit frames through an internal path to
verify the health of the transmitter and receiver path.
Note When the port's link state changes, its operational status (swFCPortOpStatus) is
affected.