Technical data
Fabric OS MIB Reference Manual 5-29
Publication Number: 53-0000521-08
Fibre Channel Port Group
5
Description This is the trap recipient associated with the community. If a new value is set
successfully, it takes effect immediately.
Note If not otherwise set, the default IP address for this trap recipient is 0.0.0.0 and the
SNMP trap is not sent for the associated community string.
With a setting of non-0.0.0.0 IP address, SNMP traps are sent to the host with the
associated community string.
Any or all of the trap recipients can be configured to send a trap for the associated
community string. The maximum number of trap recipients that can be configured is
six. If no trap recipient is configured, no traps are sent.
The trap recipient IP address should be part of the Access Control List for Fabric OS
v2.6.1, v3.1, and v4.x (refer to the agtCfgSet command).
swAgtTrapSeverityLevel
OID 1.3.6.1.4.1.1588.2.1.1.1.4.11.1.4
Description This is the trap severity level associated with swAgtTrapRcp. The trap severity level,
is in conjunction with the event’s severity level. When an event occurs, and if its
severity level is at or below the set value, the SNMP trap is sent to configure trap
recipients. The severity level is limited to particular events. If a new value is set
successfully, it takes effect immediately.
Note This object obsoletes swEventTrapLevel.
Fibre Channel Port Group
This group contains information about the physical state, operational status, performance, and error
statistics of each Fibre Channel port on the switch. A Fibre Channel port is one which supports the Fibre
Channel protocol, such as F_Port, E_Port, U_Port, or FL_Port.
swFCPortCapacity
OID 1.3.6.1.4.1.1588.2.1.1.1.6.1
Description The maximum number of Fibre Channel ports on this switch. It includes U_Port,
F_Port, FL_Port, and any other types of Fibre Channel port.
Note The valid values are as follows:
SilkWorm 3200/3250 8
SilkWorm 3800/3850 16
SilkWorm 3900 32
SilkWorm 4100 32
SilkWorm 12000 64
SilkWorm 24000 128