Installation Manual

Page 4
MODELS QTXE050 • QTXE080 • QTXE110 • QTXE150
99044375B
Order service parts by “Part No.” - not by “Key No.”
SERVICE NOTE To remove Blower Assembly: Unplug motor.
Remove thumbscrew (11) from motor plate flange. Find the
single TAB on the motor plate (located next to the receptacle).
Push up near motor plate tab while pushing out on side of hous-
ing. Or insert a straight-blade screwdriver into slot in housing
(next to tab) and twist screwdriver.
Replacement parts
can be ordered on our
website. Please visit
us at www.broan.com
INSTALL GRILLE
6. Attach grille
to housing.
Squeeze grille
springs and insert
them into slots on
each side of hous-
ing.
7. Push grille
against
ceiling.
5. Finish ceiling.
Install ceiling material. Cut out around housing.
4. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connector to secure house wiring to
wiring plate. Connect wires as shown in wiring diagrams.
CONNECT WIRING
SERVICE PARTS
Key No. Part No. Description
1 97016466 Housing
2 97016450 Duct Connector-6”
3 98010102 Wiring Plate
4 99170245 Screw, #8-18 X .375
5 97018010 Wire Panel/Harness Assembly
6 97017782 Blower Assembly (QTXE050)
97017783 Blower Assembly (QTXE080)
97017784 Blower Assembly (QTXE110)
97016591 Blower Assembly (QTXE150)
7 99140199 Grille Spring (2 req’d)
8 97017621 Grille Assembly (includes key no. 7)
9 97018014 Spacer (2 supplied)
10 QTHB1 Hanger Bar Kit
11 99420665 Thumbscrew, #8-18 x .375