Installation Guide

Page 4
MODELS QTXE050 • QTXE080 • QTXE110 • QTXE150
99044158A
TAB
Order service parts by “Part No.” - not by “Key No.”
* Not shown assembled.
SERVICE NOTE To remove Blower Assembly: Unplug motor (7). Remove
thumbscrew (19) from motor plate (9) flange. Find the single TAB on the motor plate
(located next to the receptacle). Push up near motor plate tab while pushing out on side of housing.
Or insert a straight-blade screwdriver into slot in housing (next to tab) and twist screwdriver.
Replacement parts
can be ordered on our
website. Please visit us
at www.broan.com
INSTALL GRILLE
6. Attach grille
to housing.
 
springs and insert
them into slots on
each side of hous-
ing.
7. Push grille
against
ceiling.
5. Finish ceiling.
Install ceiling material. Cut out around housing.
4. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use
proper UL approved connector to secure house wiring to
wiring plate. Connect wires as shown in wiring diagrams.
CONNECT WIRING
SERVICE PARTS
Key No. Part No. Description
1 97016466 Housing
2 97016450 Duct Connector-6”
3 98010102 Wiring Plate
4 99170245 Screw, #8-18 X .375
5 97016932 Wire Panel/Harness Assembly
6 99020297 Blower Wheel
7 99080607 Motor (QTXE050)
99080608 Motor (QTXE080)
99080609 Motor (QTXE110)
99080610 Motor (QTXE150)
8 99260423 Nut, Hex Flange #8-32 (4 req’d)
9 97017778 Motor Plate
* 97017782 Blower Assembly (QTXE050)
* 97017783 Blower Assembly (QTXE080)
* 97017784 Blower Assembly (QTXE110)
* 97017785 Blower Assembly (QTXE150)
(includes key nos. 6 thru 12)
10 99500397 Insulation (QTXE150 only)
11 99420648 Threaded Stud
(QTXE150 only) (4 req’d)
12 99260570 Plastic Nut (QTXE150 only) (4 req’d)
13 99140199 Grille Spring (2 req’d)
14 97017621 Grille Assembly (includes key no. 13)
15 99111293 Spacer (2 supplied)
16 QTHB1 Hanger Bar Kit
17 99420665 Thumbscrew, #8-18 x .375