Manual

BR., AN
INSTALL DUCTWORK
(Ducted Hoods Only)
ROOF CAP
31A'' X 10" or
7" ROUND DUCT
(For vertical
discharge)
CABINET
HOUSE WIRING
or Back of hood)
WALL CAP
t
18" - 24" ABOVE
COOKING SURFACE
31A'' X 10" DUCT
(For horizontal discharge)
IT I Determine whether hood will discharge vertically (31A'' x
10" or 7" Round), or horizontally (31/4,'x 10" only).
r_ Decide where the ductwork will between the hood
run
and the outside.
rq
Choose a straight, short duct run to allow the hood to
perform most efficiently. Long duct runs, elbows and
transitions will reduce the performance of the hood. Use
as few of them as possible. Larger ductwork may be
required for best performance with longer duct runs.
F1 Install wall or roof Connect metal ductwork to
cap cap.
cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.
QML SERIES
Page 3
PREPARE HOOD LOCATION
FI
Use the proper diagram below for placement of ductwork
and electrical cutout in cabinet or wall. For a non-ducted
installation, DO NOT cut a duct access hole.
l 31A'' X 10"
HOOD MOUNTING SCREWS (5) VERTICAL DUCTING
_F 1315/16''(30''
I.rOAB'NET_RONT
"n,:e I CABINET I_,. •
H_,!i BOTTOM I°_ 71/2"
II
I {,:'1 t I I VERTICALDUCT 1 91/21'1
/li_il_ I' ! I ACCESSHOLE lid
WOOD SHIMS t ELECTRICAL
recessed-bottom CENTER ACCESS HOLE
cabinets only) LINE (incabinet bottom)
1
101/2"
f
I
WOOD SHIMS I 3W' X 10"
(recessed-bottom [ HORIZONTAL DUCTING
cabinets only) CABINET FRONT 3/4"
LL_L,, / Illl_l:__/j1/8" I]
- - 1!-,- -
/ 3¾"'| HORIZONTAL DUCT" "-,_CC&SS
HOLE
CABINETJr_I
BOTTOM
•-1 315/16"(30''
HOOD t
ELECTRICAL
MOUNTING CENTER ACCESS HOLE
SCREWS (5) LINE (in wall)
L 7-IN. ROUND
HOOD MOUNTING SCREWS (5) DUCTING
315/18"(30" hood) 1
1
101/2 ''
WOOD SHIMS t ELECTRICAL
(recessed-bottom CENTER ACCESS HOLE
cabinets only) LINE (in cabinet bottom)
* Note the extra wood shim and mounting screw near the
cabinet front, on the cabinet center line.
_1 Install 4 Hood Screws into shims/cabinet
Mounting
according to proper diagram above. Do not tighten
completely. Do not install middle screw until Step 20.