MODELS BILBO« ILB11 Page 1 READ AND SAVE THESE INSTRUCTIONS a FOR DOMESTIC COOKING ONLY A WARNING OH a WARNING H ba TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2.
TYPICAL INSTALLATION MOUNTING (New Frame Construction) MODELS BILBO« ILB11 TYPICAL INSTALLATION "7 MOUNTING USING HANGER KIT (included) 10° ROUND DUCT (OUTLET) To Ron Tetons 10° ROUND DUCT (INTAKE) GRILLE NUT {Install info square : SE holes in housing) \ Ventilator ® factory-shipped MOUNTING BRACKETS in straight-through o ! ’ CEILING discharge position 7 JOIST {24" centers shown} ACCESS PANEL ACCESS PANEL SCREW | Factor-shipped unit installed in new construction.
WIRING Tee EDGE OF HOUSING GROUND TO WIRING PLATE WIRING 120 VAC LINE IN {from range hood) Ventilator can be wired from onside of housing. UL approved connectors to wire per local codes. MOUNTING OPTIONS 14-20 hex nuts secure mounting brackets fo housing. Loosen and re-tighten or remove and replace nuts as necessary for desired mounting bracket position.
MODELS BILBO« ILB11 Page 4 USE AN D CARE To clean blower assembly: Remove access panel, unplug blower from housing, remove blower mounting nuts, and carefully remove Follow wiring instructions packed with range hood, and adhere to blower from housing. Use appropriate vacuum attachment or a all local and state codes, and the National Electrical Code. soft cloth and mild soap or detergent to clean blower discharge area and wheel.
