Specification Sheet

Noise level
0.4 sone @ 105 cfm at grille with 5’ of  exible ducting (tested in accordance with ISO 5136 and HVI 915).
Speci cations
Model : Broan ERVS100
Part number: ERVS100S
Total assembled weight including packaging: 40 lbs.
Metallic round ports: 6" diameter
Built-in magneted backdraft damper to close outside fresh air supply when the unit is turned o
Energy recovery core:
-Type cross  ow
-Media membrane: Polymerized paper with aluminum
Core  lters: 2 washable  lters 20 PPI
Housing material: galvanized steel 22 ga
Door and door frame material: White pre-painted steel 20 ga
Insulation material: Molded Expanded polystyrene, UL certi ed for Energy recovery ventilators requirements
Supply and exhaust blower motors:
-PSC motors
-Protection type: Thermally protected
-Lock rotor electronic detection stops unit if motors failed
Installation brackets: included in unit, allow attic, in ceiling and under ceiling installations. Units must be installed with door on bottom or
upside down. No vertical installation allowed.
Unit electrical characteristics
-Power cord 28" with 3 prongs
Volts Frequency Ampere Watts
120 60hz 0.9 103
Low voltage connections for optional controls energized by unit
Optional controls wiring
-Broan VB20W 20 min push-button control: Activate 105 cfm speed in all ventilation modes (recommanded when the unit exhausts
from a bathroom).
-Dry contact standby switch (Broan 69W and 69V): Unit remains powered on, but is put on Standby mode when the switch is
turned on.
G
R
B
Y
OL
OC
I
BROAN VB20W
20-
MIN.
PUSH-BUTTON CONTROL
DRY CONTACT
S
TANDBY SWITCH
VE0359A
ON
ON
I
OC
OL
This connections allows the operation of VB20W push-button controls even if the dry contact standby switch is turned o .
R RED
Y YELLOW
B BLACK
G GREEN