Technical Specifications

ENERGY RECOVERY VENTILATOR
THE BROAN ERVH100 UNIT IS A NEW GENERATION
OF HEPA FILTRATION
Indeed, this energy recovery ventilator is equipped with a HEPA filter
that removes 99.97% of allergens and other microscopic particles in
the air. ERV technology is a great choice to increase the comfort of the
living areas as it balances the moisture level of the incoming fresh air,
making it not too humid in summer and not too dry during winter.The
Broan ERVH100 unit has an ultra-quiet operation, barely audible at low
speed (2.5 sones), thanks to the advanced design of its blower, which
also contributes to its high energy efficiency. Furthermore, since the
Broan ERVH100 ducting diameter is reduced to 5 inches, its installation
is now easier and faster than before.
• 5-in. diameter ports mean smaller duct to ease installation
• Integrated control
• Removable terminal block to ease optional wall control connections
• Integrated pressure taps
• Ultra-quiet operation
• Furnace interlock capability
• ENERGY STAR® qualified
REPAIRS AND MAINTENANCE
All parts of the Broan ERVH100 unit that could need maintenance can
be removed in less than five minutes, allowing direct access for easy
repairs. The PSC motor is permanently lubricated.
WARRANTY
The Broan ERVH100 unit is protected by a 5-year warranty on parts
only. The energy recovery core is covered by a 5-year warranty, with
the original proof of purchase.
Available at:
Controls
• This unit is very simple to operate: once it is installed, press on its
push button, located on the bottom of the electronic compartment,
to activate it. Press once for low speed, once again for high speed,
and once more to stop it.
• For more convenience, this unit can also be controlled by an
optional main control. For a complete list of optional main and
auxiliary controls available, refer to the Wall Control Compatibility
Chart on last pages of wall controls speci cation sheet, available at
www.broan.com.
• For more details about controls, refer to the Main and auxiliary wall
controls user guide, also available at www.broan.com.
Options
• Dual exterior hood kit (including Tandem® transition),
part no. VTYIK1
• Complete line of registers and di users
Homeshield™ Defrost System
When the outdoor temperature is below 23°F, energy recovery creates
frost in the core. To maintain its proper operation, the Broan ERVH100
unit is programmed to defrost the energy recovery core, using a unique
defrosting method. No negative pressure is created by air exhausted to
the outdoor, as the air is recirculated into the house, helping to prevent
any backdraft.
Energy Recovery Core
Dimensions: 10 in. x 10 in. x 10 in. (25.4 cm x 25.4 cm x 25.4 cm)
Exchange surface: 70 sq. ft. (6.5 m)
Weight: 5 lb. (2.3 kg)
Material: Polymerized paper
Type: Cross flow
Warranty: 5 years
Requirements and standards
• Complies with the UL 1812 requirements regulating the installation
of Energy Recovery Ventilators
• Complies with the CSA C22.2 no. 113 Standard applicable to ventilators
• Complies with CSA C444 requirements regulating the installation of
Energy Recovery Ventilators
• Technical data was obtained from published results of tests relating
to CSA C439 Standards
• HVI certi ed
• ENERGY STAR® qualified
OUTDOOR TEMPERATURE DEFROST CYCLE
°F °C DEFROST / AIR EXCHANGE
WARMER THAN 23 WARMER THAN -5 NO DEFROST
FROM
23 TO 5 FROM -5 TO -15 6 MINUTES / 40 MINUTES
FROM
5 TO -17 FROM -15 TO -27 7 MINUTES / 25 MINUTES
-17 AND LESS -27 AND LESS 10 MINUTES / 20 MINUTES
VB0245
This product earned the ENERGY STAR® by meeting strict energy e ciency guidelines set by Natural Resources Canada and the US EPA. It meets ENERGY STAR requirements only
when used in Canada.
Broan ERVH100
Part no. ERVH100S
50 to 100 CFM (0.4 in. w.g.)