Installation manual

2. PREPAREINSTALLATION (CONT'D)
Parts sold separately:
-Shielded halogen bulbs (120 V, 50 W max., MR16 with GUIO base) (2 for 36" width hood and
3 for 48" width hood)
- AEEPD Series Decorative flue, to be installed over the hood (optional)
- AWEPD Series Wall extension, 36" or 48" width (optional)
- Transitions, duct, elbows, dampers, wall and roof caps
Refer to page 3 for a complete list of venting options and model numbers.
NOTE: During installation, protect countertop and/or cooktop.
3. INSTALLWALL EXTENSION(OPTIONAL)
AWEPD Series
Wail extension must be installed before the hood (see instructions packed with wail extension).
4. REMOVE KNOCKOUTOPENING
Punch out the electrical knockout hole on the back of
the hood. install the wire clamp (included in parts
bag).
HR0073
,
A.
B°
REMOVEBAFFLE FILTERSAND GREASEDRIP RAIL
Remove tape on filters.
Remove filters from hood and set aside.
NOTE: It is recommended to start with the center one(s).
Remove tape on grease drip rail (1).
Lift out grease drip rail and set aside.
A B
-5-