Operating instructions

CBD1 SERIES
Page 6
CONNECT THE WIRING
INSTALL LIGHT BULBS
23 Install (2) Halogen Bulbs. Use 120 V, 35 W, shielded
halogen bulbs - MR16 with GU10 base.
NOTE: Suction Cup Tool (included with hood) can be
used to install and remove light bulbs.
Align pins on bulb with large diameter opening on socket,
then push bulb in towards hood and rotate clockwise until
firmly seated.
The position of the bulb socket (depth) is adjustable and
may require adjustment when:
a) certain brands of bulbs are difficult to install.
b) the bulb protrudes too far below the light panel.
21 Connect House Power Cable to range hood wiring -
BLACK to BLACK, WHITE to WHITE, and GREEN or
BARE WIRE to Ground Screw.
HOUSE
POWER CABLE
GROUND
SCREW
(1)
PUSH IN
CAUTION: Bulbs may be hot. Always allow bulbs
to cool before removing them.
(2)
ROTATE
CLOCKWISE
SUCTION
CUP TOOL
HALOGEN
BULB
22 Re-connect lamp wire harness and re-attach bottom panel
with (8) screws as shown in Step 9.
To change the depth of bulb sockets:
- Remove bottom panel (See Step 9).
- Disconnect light harness.
- Loosen 2 Screws holding Lamp Socket Bracket to
Light Panel.
- Adjust socket/bracket to desired depth.
- Re-tighten screws securely.
- Re-attach light harness and replace bottom panel.
LIGHT PANEL
LAMP SOCKET
BRACKET
SCREWS
24 DUCTED INSTALLATION ONLY:
Re-install aluminum filters removed in Step 8.
NON-DUCTED INSTALLATION ONLY:
Purchase a non-ducted filter (Model BPQTF) from your
local distributor or retailer. Attach the non-ducted filter
following instructions packed with the non-ducted filter.