Operating instructions

CBD1 SERIES
Page 4
13 DUCTED INSTALLATION ONLY:
Remove Baffle from Slot above air box.
FOR NON-DUCTED INSTALLATIONS - Skip to “INSTALL
THE HOOD”.
14 DUCTED INSTALLATION ONLY:
Rotate Baffle and insert long side into Slot above air
box. Baffle is inserted properly when you feel a positive
stop.
11 Remove 2 Screws holding Damper / Duct Connector to
hood. Remove damper/duct connector from inside the hood.
DAMPER /
DUCT
CONNECTOR
9 Remove 8 Screws holding Bottom Pan to hood.
Disconnect Light Harness.
(4)
(4)
CONTENTS
8 Remove the
Aluminum Filter
from the hood by
pulling the tab
down and lifting
filter out.
7 Remove all
protective polyfilm
from the hood
(stainless steel
hoods only).
ALUMINUM
FILTER
ç
(1)
PULL
DOWN
(2)
LIFT
OUT
ç
BAFFLE
SCREWS
12 Remove 7” Round Duct Plate from top/back of hood.
7” ROUND
DUCT
PLATE
SLOT
BAFFLE
SLOT
PREPARE THE HOOD
(1) GREASE
FILTER
(1) 3¼” X 10”
DAMPER / DUCT
CONNECTOR*
(1) 7” ROUND
DUCT
CONNECTOR
(1) BULB SUCTION
CUP TOOL
(1) PARTS BAG** CONTAINING:
(5) #10 X 5/8”
RD. HD.
MOUNTING
SCREWS
* FIND INSIDE
OF HOOD
** FIND PARTS BAG TAPED TO
INSIDE OF BOTTOM PANEL.
10 Remove parts bag included with the hood. (Parts bag is
taped to inside of bottom pan.)