Technical data

7.4 INSTALLATION OF THE WALL CONTROLLERS (BOTH MODELS) (CONT’D)
6. Reinstall the cover plate. Using provided wall anchors and provided screws, mount the wall controller on the wall. Use
only 2 screws to mount on outlet box. See illustrations below.
1) Wall anchors 4) Control 1) Outlet box 3) Control
2) Control cable 5) Screws 2) Control cable 4) Screws
3) Backplate
7. Go to the unit. Remove the front panel by unscrewing its 2 retainig screws.
8. Using a small rod, pierce a hole through the unit at the end of the wire
channel. (See photo beside). Splice back the end of the cable to access the
four wires. Remove the insulated sleeve of each wire ends. Insert the end of
the cable through the unit, using the small hole previously done.
9. Looking inside the right side front port, you gain access the field wiring terminals for the
controller. Remove the side door located on the electrical box and punch out its knock
out. Run the cable through the knock-out hole and connect each wire to their
corresponding terminal (YELLOW in “Y’’, RED in “R’’, GREEN in “G’’ and BLACK in “B’’).
NOTE: Push forward slightly on the little tabs (1) to ease insertion of each wire.
See photo beside.
7. CONTROLS (CONT’D)
VC0052
VC0051
1
3
4
5
2
3
4
1
2
CAUTION
Keep control low voltage wiring at least 1’ (305 mm) away from motors, lighting ballast, light dimming circuit and power
distribution panel. Do not route control wiring along house power wiring. Avoid poor wiring connections. Failure to follow
these practices can introduce electrical interference, which can cause erratic control operations.
- 29 -
SURFACE MOUNT
RECESS MOUNT
VO0019
VD0088
CAUTION
Never use a drill to pierce the hole through the unit, since electrical component
inside the unit may be damaged.
VE0049
1