Technical data

- 15 -

6. INSTALL THE UNIT (CONT’D)

CAUTION

Make sure the unit is level.

• Verify the switch knob is in the OFF position in order to unlock the door. Unlatch the door,

using the 2 latches to open and remove by sliding it out of its hinge. Using a screwdriver,

remove the two retaining screws of the front plate as shown, and carefully remove the front

plate from the unit.

• Insert the four hooks in the square holes and fix them to the unit using four screws #8 - 32 x 3/4”.

DO DO NOT

VO0019

VO0020

6.4 FOR SUSPENDED APPLICATIONS (CONT’D)

If preferred, the door can be removed. First, remove the stopper (A) located on the right side of the

door hinge, then, slide the door out of its hinge.

VD0170

CAUTION

Take care to insert the screws perpendicular to their hooks, in order to avoid potential damages due to loosen hooks.

See illustrations below.

VO0063