DELUXE ELECTRIC POWER BRUSH MODEL: BN200 ! FOR HOUSEHOLD USE ONLY ! AB0008 HOMEOWNERS OPERATING INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Broan-NuTone Canada Inc.; Mississauga, Ontario www.broan.ca or www.nutone.ca 1-888-882-7626 Register your product online at: www.broan.ca or www.nutone.
The instructions given in this booklet serve as a guide to routine maintenance. To obtain the most satisfying years of service, read through these instructions and keep them handy for future reference. IMPORTANT SAFETY INSTRUCTIONS When using an electric appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THE POWER BRUSH. WARNING TO ! REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR PERSONAL INJURY: 1.
1. HOW TO ASSEMBLE POWER BRUSH/WAND/HANDLE 1. Read important safety instructions before installing power brush. 2. Ensure hose is disconnected from power supply before installing power brush. 3. Push wand into power brush neck so that the lock button snaps in place. 4. Connect hose handle into wand quick connector and ensure that the prongs are aligned with the receptacle holes. Push until lock button snaps in place.
2. HOW TO USE POWER BRUSH/WAND CAUTION Always pick up hard or sharp objects by hand before using your power brush. Items such as pins, hairpins, tacks, crayons, etc., may damage the brush roll or may break the belt. 2.1 WAND RELEASE The power brush is not recommended for use on bare floors. Wand release pedal (A) on power brush allows you to quickly disconnect wand and switch to combination floor/rug tool for use on bare floors. C A 2.
2. HOW TO USE POWER BRUSH/WAND (CONT’D) 2.6 ELECTRONIC CIRCUIT BREAKER The power brush is equipped with an electronic circuit breaker that protects the motor and the belt if a too large object is picked up accidentally. If the power brush stops while vacuuming, turn the power unit off using handle. Release the power brush from the wand and turn it over to see if there is an obstruction. When brush roll jam has been cleared, press the reset button (H) and connect the power brush back to the wand.
4. MAINTAINING THE POWER BRUSH ! WARNING Disconnect electrical supply before servicing or cleaning the unit. Failure to do so can result in electrical shock or personal injury from cleaner suddenly starting. 4.1 HOW TO CHANGE BELT FIG. 1 1. Turn power brush over and using a Phillips no. 2 screwdriver, remove the 3 brush roll cover retaining screws (Fig. 1) and set aside. 2. Remove brush roll cover. (Fig. 2) 3.
5. WAND AND HOSE COMPATIBILITY WAND PART NO. 08949 VACUUM HOSE PART NOS. 09007, 09008 & BN32DV HOSE HANDLE NOTE: If your dual voltage hose is not compatible with your new BN200 power brush, please contact Broan-NuTone customer service at 1-888-882-7626 to receive a free electrical cord (part no. CRD400-01) that will enable you to connect your new power brush to your hose. IMPORTANT: Do not return the brush to your retail store. 6. SERVICE PARTS 3 1 4 2 5 AA0002 KEY NO. 1 2 3 4 5 PART NO.
7. SERVICE INFORMATION To avoid unnecessary service calls, check the belt and brush roll often. Replace the belt if it is stretched or cracked. Clean the brush roll bristles when they are wrapped with thread and hairs. Build-up could cause the brush to rotate unevenly. The model number and serial number are indicated on the rating label located underneath the power brush. Always refer to these numbers when inquiring about service. NOTE: The motor is permanently lubricated and sealed.