Manual

BroaMan MUX22
Operating Manual
Rev. 2.1
21
MUX22 IVT/IC444
RS485/GPIO: 4 x RS485 (D-Sub-9) or GPIO (D-Sub-15) auxiliary port for data transmission
WDM ports LINK1/2: CWDM or DWDM multiplexer Input/Output for Optocore duplex fiber
connection (LINK1 and LINK2). Can be used for external fiber devices such
as Ethernet switches (see AUX1/2).
SYNC In: Tri-/Bi-Level Sync or Word Clock (software selectable) input allowing
synchronisation of Optocore devices/network and sync signal distribution via
the Optocore network from an external Sync/Word Clock source
SYNC Out Tri-/Bi-Level Sync or Word Clock output for synchronization of external
devices
Coaxial ports 1-8: Can be equipped with:
• 3G/HD/SD-SDI (reclocked) inputs in pairs of two
• 3G/HD/SD-SDI (reclocked) outputs in pairs of two
The coaxial ports are connected internally to SFP fiber transceivers that feed
the specified CWDM or DWDM multiplexers.
WDM port COM1: Combined duplex fiber port of internal WDM, CWDM or DWDM No.1
WDM port COM2: Combined duplex fiber port of internal WDM, CWDM or DWDM No.2
WDM port AUX1: Auxiliary duplex fiber port of internal WDM, CWDM or DWDM module No.1,
provides connectivity for external fiber devices such as Gigabit Ethernet
switches or any other third party optical connection.
WDM port AUX2: Auxiliary duplex fiber port of internal WDM, CWDM or DWDM module No.2,
provides connectivity for external fiber devices such as Gigabit Ethernet
switches or any other third party optical connection.
POWER 1 and 2: AC input for power supplies 1 and 2 (100 … 240 V).
Optionally: DC input for power supply 1 and 2 with 4 pin XLR Male (8 …18V)
Device Label: Audio/intercom card type and serial number of the device
AUDIO IN / GPI: 4 Line Level audio inputs, 4 General Purpose Inputs, auxiliary power +5V,
+12V
AUDIO OUT / GPO: 4 Line Level audio outputs, 4 General Purpose Inputs, auxiliary power +5V,
+12V
SANE 1: SANE RJ-45 interface for audio transmission and 100 Mbit Ethernet
SANE 2: SANE RJ-45 interface for audio transmission and 100 Mbit Ethernet
LINK 1: Full-duplex, full bandwidth LC-type optical interface for Optocore transmission
(SFP transceiver – type depending on a specyfication)
LINK 2: Full-duplex, full bandwidth LC-type optical interface for Optocore transmission
(SFP transceiver – type depending on a specyfication)
LAN 1: 100 Mbit RJ-45 Ethernet interface
LAN 2: 100 Mbit RJ-45 Ethernet interface