User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
User Manual
BritePort 8120
81
6. Click the DNS Configuration tab to open the “DNS Configuration” dialog box.
Select the option Enable DNS and then enter Host, Domain, and DNS Server
Search Order provided by your DSL service provider. Click Add to apply the
change, and click OK to confirm the settings.
7. At this time, the “System Setting Change” window appears and prompts you to
restart your computer. Click Yes to proceed.
In Windows 2000/XP,
1. Click Start -> Settings -> Network and Dial-up Connections -> Local Area Con-
nection to open the “Local Area Connection Status” window.
2. Click Properties to open the “Local Area Connection Properties” dialog box.
3. In the components list, highlight Internet Protocol (TCP/IP) and click Properties
to bring out the “Internet Protocol (TCP/IP) Properties” dialog box.
4. Select Use the following IP address. Enter the IP Address, Subnet mask, and
Default gateway information provided by your DSL service provider.
5. In the same dialog box, select Use the following DNS server addresses and enter
the Preferred DNS server and Alternate DNS server information provided by
your DSL service provider, if any. To do so, you can also click Advanced to
configure your computer’s DNS server settings in the “Advanced TCP/IP Settings”
dialog box.
6. Finally, click OK to apply the new settings and click OK again to confirm all the
changes. This will bring you back to the “Local Area Connection Properties” dialog
box.
7. Click Close to close the dialog box. At this time, Windows may prompt you to
restart your computer. Click Yes to proceed.