User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
80
User Manual
BritePort 8120
20 Can I have multiple static IP addresses for BritePort 8120?
Yes. You should contact your DSL service provider for fees and details on how to
obtain more static IP addresses.
21 What should I do if I forgot my login information to access the Web-based
configuration tool of BritePort 8120?
Refer to the Chapter 2: Hardware Installation section of this User Manual, if you
forgot your login information, press the RESET button located on the backside of your
BritePort 8120. This will allow you to reset the username and password to the
manufacturing default values without changing the existing configurations. For the
default login information, refer to Chapter 3: BritePort Setup Wizard sections of this
User Manual.
22 How do I configure my BritePort 8120 to support multiple IP addresses?
For information, please refer to the Chapter 3: BritePort Setup Wizard and Chapter 4:
BritePort Configuration Tool section in this manual.
23 How do I configure my network computers for Static IP address?
In general, there are two scenarios when you need to set up your network computers for
Static IP address. The first is when you subcribe multiple Static IP addresses from
your DSL service provider and have each Static IP address being assigned to a
computer. The second is when your DSL network environment requires you to assign
each computer a specific internal IP address. In this section, we will provide
instruction based on the first scenario.
In Windows 95/98/Me,
1. Click Start -> Settings -> Control Panel to open the “Control Panel” window.
2. Double-click the Network icon to open the “Network” dialog box.
3. Click the Configuration tab, and from the list of “The following network
components are installed” select the TCP/IP with your Ethernet card, for example,
TCP/IP->Realtek RTL8139(A) PCI Fast Ethernet Adapter. Then, click the
Properties button to open the “TCP/IP Properties” dialgo box.
4. Click the IP Address tab to open the “IP address” dialog box. Select the option
Specify an IP address and enter the IP Address and Subnet Mask provided by
your DSL service provider. Then, click the Gateway tab.
5. Enter the Gateway address provided by your DSL service provider in the New
gateway field, and click Add to add the new Gateway address.