User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
72
User Manual
BritePort 8120
B. BritePort LED Status
Observe the LEDs on your BritePort to check if the device is functioning properly.
Normal Setup Status
When your BritePort is powered up, after a few seconds, all the LEDs go into their correct
states:
POWER - ON when your BritePort is connected to a power source and is
switched ON.
DIAG - OFF during normal operation. The LED will be ON only when
BritePort 8120 performs self-test at the initial power up.
LAN 1 to 4 - ON when an Ethernet connection is detected with no data traffic
detected. The LED will blink when data traffic is detected on the Ethernet port.
DSL - ON when a DSL connection is established. The LED will flash when
it is trying to establish link to the service.
C. Possible Problems
1. POWER LED on BritePort is OFF
Cause Your BritePort is not properly powered.
Solution Try the following solutions:
Make sure that the DC power adapter is firmly plugged into both the wall outlet
and your BritePort.
Be sure to turn ON your BritePort, as well as the power outlet.
2. DIAG LED on BritePort is ON
Cause Your BritePort is performing self-diagnostic.
Solution Try the following solution:
Wait for the self-test to complete.