User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
User Manual
BritePort 8120
71
Note:
For Windows 2000/XP users,
instead of the “Network” dialog
box, you will see the “Local
Area Connection Properties”
dialog box similar to Figure B-2.
Under the list box of
“Components checked are used
by this connection:”, select
Internet Protocol (TCP/IP),
and then click Properties to
open the Internet Protocol
(TCP/IP) Properties dialog
box.
3. In the “TCP/IP Properties”
dialog box (Figure B-3),
click the IP Address tab and
make sure that IP Address is
192.168.1.x (for example,
192.168.1.2) and the Subnet
Mask is 255.255.255.0.
Click OK to close this dialog
box.
4. Again click the OK button
on the “Network” dialog box
(or “Local Area Connection
Properties” dialog box for
Windows 2000/XP users) to
confirm the change settings.
5. Restart your computer when
prompted.
Figure B-2
Figure B-3