User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
56
User Manual
BritePort 8120
LAN to WAN Firewall
Refer to Figure 4-24, select
the firewall level for your DSL
network, and click Apply to
confirm your selection. If you
select the Advanced (User
Define) option, the page will
be refreshed and appears with
the options for you to further
configure the packet filtering
rules between WAN and
Primary LAN or between
WAN and Secondary LAN.
Note:
This feature is for advanced users
who have in-depth knowledge
about network configuring. Enable
the setting only if you would like to
apply packet filtering rules from
your LAN to WAN or in between
the two subnetworks on your LAN.
To find out your BritePort 8120’s
default policies of filtering rules for
various security levels, click the
The table of default policies for
various security levels link located
at the bottom of the “Application
Control” page to open the “Firewall
Policies” window similar to Figure
4-25.
Figure 4-24
Figure 4-25