User manual
Table Of Contents
- Contents
- 1. Introduction
- 2. hardware installation
- 3. briteport Setup wizard
- 4. Briteport Configuration tool
- A. Specifications
- B. Troubleshooting
- C. Frequently Asked Questions
- D. Glossary
- E. Warranty Information
- F. ContacT information
54
User Manual
BritePort 8120
Dynamic Routing
The “Dynamic Routing” page
provides the routing table that
lists the current settings,
including Interface Name,
Receive Mode, and Transmit
Mode. The default mode is
set to have RIP disabled.
Refer to Figure 4-20, use the
drop-down boxe to select the
Interface Name and the
desired RIP settings for each
interface. Finally, click Apply
to confirm all the settings.
DNS
The “DNS” page allows you to configure the DNS Relay and DNS Server for your DSL
network.
DNS Relay
The “DNS Relay” page,
similar to Figure 4-21, allows
you to Disable or Enable the
DNS Relay. If Enabled is
selected, you can click
Configure to open the “DNS
Relay” configuration page.
Figure 4-20
Figure 4-21